Solar Nirvana?

The weather for astrophotography in Florida is so dismal in the summer, or rainy season as I call it. Even when it’s bright and hot outside, there’s a haze of moisture and thin clouds most days, and the nights are quite opaque. We had a break the other morning and I had a chance to get out some new gear I’ve been curating. I think my solar rig is “almost” as good as I can hope for, and I captured a nice view of the Sun the other morning (7/26/2024) and Active Region 3762.

I have a DayStar Quantum 0.5 Angstrom Ha filter. This is a very specialized filter for capturing light just from glowing Hydrogen in the Sun’s atmosphere. It reveals an amazing amount of surface details, and it works on the back of most any refractor as long as it isn’t too big. I will be honest, it’s an advanced piece of astro-gear, and I struggled a bit to get the tip top performance out of it for a while. Focal ratio matters, sort of. What really matters is nice parallel rays of light coming into it, and certain optics technically change the focal ratio, but don’t necessarily produce the most parallels rays. I also have found, despite my earlier confidence, that a front mounted energy rejection filter helps a great deal (ERF). I bought an 82mm Lunt ERF second hand in a custom 3D printed cell that fits my Astrophysics Stowaway telescope. I use a TeleVue Powermate or a Baader 4X Telecentric on the back to get the focal ratio/parallel light rays going.

Other luxuries in this photo. A Paramount MYT with absolute encoders, which is an absolute joy to use. Already aligned and ready to go, you just flip a switch and go. The scope is an Astro-Physics Stowaway refractor, there’s a waiting list and/or lottery to get  these fine refractors. I really think Roland Christen is the modern Alvan Clark. There’s a top of the line Feather Touch focuser on the back, and an Optec QuickSync motor on it. Finally, a Player One Apollo Max on the back is taking the images. One further improvement is a cooled camera. There’s some debate as to if this really helps with solar imaging, but I do find that the fact that the temperature is regulated does make a big deal. Not so much that it’s “reducing noise” in the raw images, but calibration frames need to be at the same temperature if you you want the flat frames to work properly. Nine times out of ten, it doesn’t seem to matter, but occasionally, I’ll end up with flats that won’t work, and this is the reason why. Some helpful advice… “Just keep your optics clean”… makes me laugh.

I think this is just about as good as it gets for a high quality solar rig for myself. I might have to get a 3D printed cell for that ERF to fit my Esprit 150 though. It’s only taken some 30+ years of wheeling and trading up to get here. As Ferris Beuler says, “If you have the means“… maybe you won’t have to wait 30 years 😉

Now… how about some clear skies?